FraMCoS 11 2023 Bangalore, India

Fatigue-induced concrete fracture under combined compression and shear studied using standard cylinder and refined punch-through shear test setup

To characterize the fatigue behavior of concrete, the standard cylinder test has been widely used for several decades. It is used as an essential test for investigating the uni-axial compressive fatigue behavior of concrete. However, the observed failure mechanism is…

First page of: Fatigue-induced concrete fracture under combined compression and shear studied using standard cylinder and refined punch-through shear test setup
Year 2023
Downloads 2
File Size 1.4 MB
Download PDF (1.4 MB)

Abstract

To characterize the fatigue behavior of concrete, the standard cylinder test has been widely used for several decades. It is used as an essential test for investigating the uni-axial compressive fatigue behavior of concrete. However, the observed failure mechanism is primarily ascribed to the formation of shear bands during the later stages of fatigue life. This localized material zone exhibits an uncertain combination of shear and compressive stresses. An alternative test setup, referred to as refined punch-through shear test (PTST), has been introduced with the goal to enable an accu- rate control of a combined shear and compression fatigue loading. Initial experimental studies have shown that this setup leads to an enormous reduction in fatigue life scatter and an improvement in reproducibility due to a better control of the stress state in the localized zone. To analyze and inter- pret the experimental results, the microplane fatigue model MS1, recently introduced by the authors, is used. It aims to capture the fundamental inelastic mechanisms driving the tri-axial stress redistri- bution within a material zone during the fatigue damage process in concrete. Numerical studies are first presented to evaluate the stress profiles on a cylinder test before and after damage localization. Then, numerical simulations of PTST response under various levels of confinement can reproduce the monotonic and fatigue behavior of the tests. Finally, an analysis of the energy dissipation of the PTSTisperformedforcyclic loading under two different levels of confinement.